Why does my TDRFORCE BW1020A Water Pump not shut off?
Your TDRFORCE Water Pump may not shut off because of several reasons: * There may be leaks at the tubes, tube fittings, or other connections. If so, fix the leaks. * The pressure switch may have failed. Check the pressure switch by turning the faucet off and on. * The float switch might be stuck. Verify the float switch position in the bottle and ensure it can move freely.
What to do if TDRFORCE Water Pump dispenser doesn’t pump water?
If the TDRFORCE Water Pump dispenser isn’t pumping water, consider these possible causes and solutions: * **Power failure:** Check the power supply. * **Long time unused:** Keep the power on and manually fill some water from the inlet pipe. Try several times until it starts pumping. * **Buoy of the inlet pipe stuck:** Check the buoy to ensure it can move freely. * **Empty bottle:** Refill the bottle.
Why is my TDRFORCE BW1020A Water Pump outlet leaking?
If the outlet of your TDRFORCE Water Pump is leaking, it could be due to: * **Installation error:** Ensure you push the tube all the way into the tube stop. * **Loose connection:** Fasten the connection between the dispenser and the machine. * **Cracked tubes:** Replace any cracked tubes.
What to do if TDRFORCE Water Pump turns off and on continuously?
If your TDRFORCE Water Pump turns off and on continuously while in use, it could be due to an installation failure. Check for any restriction devices at the appliance inlet and inspect for a filter unit in the line.
Describes the process to remove the plug from the fitting.
Instructions for installing the suction wand into a bottle.
Steps for removing and changing bottles with the suction wand.
Procedure for initiating the system after installation.
Step-by-step guide for cleaning the dispensing system.
General| Brand | TDRFORCE |
|---|---|
| Model | BW1020A |
| Category | Water Pump |
| Language | English |
To Next Page
