16
Settings on your Unit
Tap Start / Settings. Tap any of the icons on the Personal,
System or Connections tabs to customize the unit settings to your
own preferences. Tap OK to exit the settings. Some of the more
useful settings are described below.
Lock (password)
If you want password protection from unauthorized use of your
unit, tap Personal / Lock. The password must be entered every
time you turn the unit on or resume operation.
WARNING: BE CERTAIN TO REMEMBER THE
PASSWORD. The only way to recover from a forgotten password
is to perform a Clean Boot. However, you will LOSE all
application software, licenses, settings and data on your unit. See
page 12 about how to perform a Clean Boot.
Buttons (keys)
Tap Personal / Buttons. You can assign your favorite programs
to several of the keypad buttons. The list of assignable keys is
shown on the left hand side with the program that is assigned by
default on the right. To reassign a key, select the key you wish to
change in section 1 and choose the desired program or action from
the pull-down list in section 2.
If your unit has the numeric data keypad, the yellow
function
key (sticky FN) accesses the tasks in yellow, including the
Navigation arrows. There are several settings that can be changed
under Keyboard Options.
Auto release: Press and release the function key to access a
yellow task for one use. It then goes back to the keytop tasks.
Manual release: This is the default. Press the function key to
toggle it on and off. Yellow tasks remains active until the
function key is pressed again to input the keytop tasks.
Disabled: The function key has to be held down while pressing
any other key to access the yellow task.
Play Sticky Key Sounds: To turn the sound off for sticky key
sounds, remove the check in the box.
To Next Page
Loading...