Teac CD-5 - ADJUSTMENT AND CHECKS; Pickup Replacement and Safety

CD-5
4 ADJUSTMENT AND CHECKS
at £1
1. Replacement of the pickup assembly
@ Before removing the pickup assembly be sure to solder
~bridge where indicated in the inset (Fig. 4-1) to prevent
the laser diode from being electrostatically damaged.
After replacing the pickup assembly, be sure to unsolder
the antistatic bridge. Or else the laser diode does not
function.
@ Before servicing the pickup assembly be sure to prevent
electrostatic-inducer destruction by grounding not only
test equipment in use but also yourself as shown in
Fig. 4-2.
* Electrostatic charge drastically shortens the operating
life of the laser diode or possibly results in its
destruction.
@During the transportation, mounting and dismounting
of the assembly, support with your fingers at points
A and B as shown in Fig. 4-3. Be particularly careful
not to touch the actuator, photosensor and LD plate
and do not apply force to them.
@ Soldering must be done quickly at less than 30W, 320°C.
@Don’t disassemble the pickup ass’y.
@Don’t apply shock to the pickup ass’y.
@Don’t place the assembly in a place subject to excessive
dust, heat or moisture.
PCB
Chassis (GND)
DD
Fig. 4-1
2. Objective
@Laser beams are similar to infrared rays. Don’t look at
the beams directly and keep your eyes at least 30cm
away from them.
@Don’t touch the objective with fingers.
@If objective becomes dirty, playback will deteriorate.
To clean the objective, moisten a good cleaning tissue,
such as made by KODAK, in isopropyl alcohol and wipe
the objective gently. Wipe off and excess fluid with a
dry cleaning tissue.
Earth ring
(Lead wire)
Pick-up case
1.E 77» 7 ASSY O25H8
@ty 77 xTSASSY EATER. V-F-F14- FORB
BURIED KD, ASRRERS (Fig. 4-1L) EKA TY yo YUT
DOMBELTCRSAW. Ek. MOV SZBASMRO AIK
Bie4ATY y VEALTCR SW,
MAT) yVELKEECAIL-¥-P4A— FUEL EL
Ao
OEY IT YTASSY FMORABA. MESS IKE
T-AREMS LH. MAT - ASAIO, MRA OBIE
LTC KRU. (Fig. 4-2)
AL-¥-SAA— Pid, PBAMMDS & Ams BPE
LEO. EKIUMHBLETOCTAERLTC KS,
@MOM. MOAL, HEMVOBI, Fig. 4-30 AME BH
CRATC HEU, BIT 7 Fat—9—, KRM, LDS
V— habit, FRANK YOASMAKRY LEWES KAU,
@ “HAF lL 30W, 320°CL F HHA L. TIE < MHEL TC KS
Wo
@CY7IT y SASSY AKO MBS KOGA EI LEWC CK
SW
@CY7T YTASSY (BE + PBUMALOT KEW,
@Ti -hIVGCORET 41M. M+ SHOW T
CHEK
LD Plate
Resistor
IMQ~10MQ
Photo Sensor
Earth
Fig. 4-2 Fig. 4-3
2. MU YAICDIT
OL —F-HlAAAROAAGIARCHT, HOREOA, FH
RLY AAS 20cm LA LEBEL TC KEK
@VY ACFE MNEE CK EU,
@VVAILBNAT <¢ CBEREFI AVR RFLET OC. ROL GK
LTC REW,
VY RIV -aVIR—/8— (KODAKHHWE LY) KK. P70
E-WVF VAN (LP.A) EBL CAS L. RORMOK UE
DMF RE Era TCKR AU
anne