Teac CD-RW901SL - Page 16

TASCAM MD-CD1 RS-232C Protocol Specification
15 TEAC Corporation
TIME SEARCH PRESET
Searches for the specified track number and time.
If this command is received while in STOP mode or PLAY mode, the device will enter PLAY mode
following the search. If the device was in any other mode, it will remain in that mode following the
search.
Command 2C
Machine ID 0
Data 12 bytes
Description Remarks
Data 1 Tens digit of track
number
Data 2 Ones digit of track
number
Data 3 Thousands digit of
track number
Data 4 Hundreds digit of
track number
Data 5 Tens digit of
minutes
Data 6 Ones digit of
minutes
Data 7 Hundreds digit of
minutes
Data 8 Thousands digit of
minutes
Data 9 Tens digit of
seconds
Data 10 Ones digit of
seconds
Data 11 0 Set to 0
Data 12 0 Set to 0
・ If a track number not existing on the disc is specified, the CD-RW901 will transmit ILLEGAL
[F2].
・ If data outside the operating range is received, the CD-RW901 will transmit ILLEGAL [F2].
Return none
KEY CONTROL DATA PRESET
Specifies the playback key of controlled device.
A range of ±6 semitones can be specified.
A return command is returned only if Sense [FF] is specified.
The KEY CONTROL MODE setting is made using the command "KEY CONTROL SELECT [3D]."
Command 2D
Machine ID 0
Data 2 bytes
Data 1 Data 2 Description Remarks
0
1
Key Up
Key Down
0 – 6 Key Change Semitone units
F F Sense Requests that the preset content be returned.
・ If data outside the operating range is received, the CD-RW901 will transmit ILLEGAL [F2].
Return KEY CONTROL DATA RETURN [AD]