Loading Data to and Copying from the Hard Disk Source Drive
12 TEAC DVD Duplicator User’s Manual
Note:
❑ With the default setting, after source data has been successfully copied to the
target DVD disc, the DVD Duplicator automatically ejects the disc.
❑ With the default setting, if the copy operation fails, the failed target DVD disc
remains in the target drive. To remove the failed DVD disc, press the eject
button on the target drive and retrieve the disc. Then press the eject button
again to retract the disc tray. You can change the default settings by using
the [Advanced Setup] menu. (See “12 Advanced Setup (Adv Setup)” on
page 19.)
TEACdvwd11.book Page 12 Sunday, May 1, 2005 6:04 PM
To Next Page
Loading...
