12.1 UnderRun Protect
20 TEAC DVD Duplicator User’s Manual
12.1 UnderRun Protect
The UnderRun Protect setting turns Buffer UnderRun Protection on or off. The
default setting is ON.
12.2 Overburn
The Overburn setting turns the Overburn function in the target drive on or off. The
default setting is OFF.
12.3 Read Error Skip
The Read Error Skip setting controls error skipping during reading of the source
disc.
If the setting is OFF and an error is detected, the target drive stops and displays
the read error message.
If the setting is ON, no messages will be displayed if an error occurs. The copy
operation will be completed and the copy will include all errors detected during
the process.
The default setting is OFF.
12.4 Format HDD
(For factory use only; please do NOT use this function.)
The Format HDD option is valid only on DVD Duplicators that feature a factory-
installed hard disk drive. The factory-installed hard disk drive has already been
partitioned and formatted and is ready for use.
12.5 Verify HDD
(For factory use only; please do NOT use this function.)
The Verify HDD option is valid only on DVD Duplicators that feature a factory-
installed hard disk drive. The factory-installed hard disk drive has already been
partitioned and formatted and is ready for use.
Warning! Do not run this function. It will erase all data already loaded into disk
partitions. This function is reserved for factory use only.
Warning! Do not run this function. It will erase all data already loaded into disk
partitions. This function is reserved for factory use only.
TEACdvwd11.book Page 20 Sunday, May 1, 2005 6:04 PM
To Next Page
Loading...