Teac SB20204 - Troubleshooting; Product Specifications

TROUBLESHOOTING
If you are experiencing any issues with your device please refer to the below table for a soluon.
ISSUE POSSIBLE CAUSE/SOLUTION
No power/funcon
Check whether the power is switched on or o
at the wall.
Check whether the power adaptor is
properly connected to the power outlet.
No sound
Check whether cables are properly installed.
If they are, please try an alternave cable to
connect to your TV if possible.
Check unit is out of standby mode.
No sound from Bluetooth connecon
Forget the soundbar from your device and
reconnect.
Funcon disturbance
Switch o and unplug the unit. Leave it for
2 minutes and switch it on again.
If a parcular mode is causing problems,
please try an alternave connecon to
your TV such as Opcal or Bluetooth.
Remote control does not work properly
Check whether the baery has run out or not.
Replace with a new one if necessary.
Check whether there is an obstacle in
front of the remote sensor.
Power Supply DC 12V / 1.0A
RMS Power 12W
Speaker Output Power 20W
Speaker Size & Number
5090mm Full range speaker x 2 + Passive speaker
x 1
Bluetooth Version 5.0
Bluetooth Distance 10M
Frequency Response 100HZ - 18KHZ
Working environment -10~ +55C
Audio Input Line-in / USB / Bluetooth
Soundbar Dimensions 76 x 5.5 x 6.5cm
Net Weight 1.03kg
PRODUCT SPECIFICATIONS