Teac T-H300 - Before Operating; Unit Placement and Care; UK Mains Plug Safety

Table of Contents
Al Function......
Connections and Rear Panel Overview
Antenna Installation ...
Front Panel Controls and Their Functions
Display.....
Listening to Radio Broadcast...
How to Preset Broadcasting Manually
How to Preset Broadcasting Automatically.
Sleep Timer......
Adjusting Current Time.
Major Reception Symbols of RDS Data
RDS Display.
PTY Search.
Specifications.
Troubleshooting ..
SSSSevmmeOOUUNUda obs
Before Use
ee
Read This Before Operating
* Place the unit on a hard flat surface.
* Avoid placing it in direct sunlight or close to
a source of heat. Also avoid locations
subject to vibrations and excessive dust,
heat, cold or moisture.
* Do not open the cabinet, as this might result
in circuitry damage or electrical shock.
* Do not attempt to clean the unit with
chemical solvents, as this might damage the
finish. Use a clean, dry cloth.
Al Function
For more information, see the owner's
manual of the A-H300.
* If you press the following buttons with Al
function of the amplifier on, you can
listen to radio broadcasting easily.
For example
If you press the following, without pressing
the stop button while listening to a tape,
you can listen to radio broadcasting.
Tuner : T-H300
band button (preset tuning mode)
Amplifier : A-H300
input selector to tuner
Remote control unit : RC-613
tuner button
band button
preset call button (& or W )
IMPORTANT (for U.K. Customers)
DO NOT cut off the mains plug from this
equipment. If the plug fitted is not suitable
for the power points in your home or the
cable is too short to reach a power point,
then obtain an appropriate safety approved
extension lead or consult your dealer.
If nonetheless the mains plug is cut off,
remove the fuse and dispose of the plug
immediately, to avoid a possible shock
hazard by inadvertent connection to the
mains supply.
If this product is not provided with a mains
plug, or one has to be fitted, then follow the
instructions given below:
IMPORTANT. DO NOT make any connection
to the larger terminal which is marked with
the letter E or by the safety earth symbo + or
coloured GREEN or GREEN-and-YELLOW.
The wires in the mains lead on this product
are coloured in accordance with the
following code:
BLUE: NEUTRAL
BROWN: LIVE
As these colours may not correspond with
the coloured markings indentifying the
terminals in your plug proceed as follows:
The wire which is coloured BLUE must be
connected to the terminal which is marked
with the letter N or coloured BLACK.
The wire which is coloured BROWN must
be connected to the terminal which is
marked with the letter L or coloured RED.
hen replacin onl Id
rated appre hould
sur -fit the fuse cover.
IF IN DOUBT - CONSULT A COMPETENT
ELECTRICIAN.
If this unit is supplied separately, please
ensure that it has a correctly wired and
fitted UK mains plug.
ENGLISH