Teac T-H300DAB User Manual

5
CAUTION
Turn off the power of all the equipment before
making connections.
Read instructions of each component you intend to
use with this unit.
<
Be sure to insert each plug securely. To prevent
hum and noise, do not bundle the connection
cords with the power cord.
AUDIO OUT jack
Analogue 2-channel audio signal is output from
this jack.
Connect the component with RCA pin cable.
AUDIO OUT (T-H300DAB)
w
TUNER IN (amplifier)
Make sure to connect :
white plug
w
white jack (L: left)
red plug
w
red jack (R: right)
DIGITAL OUT terminal
DAB’s digital audio signal is output from this
terminal. If you want to record digitally, or decode
the signal using an external digital decoder,
connect the component with an optical cable.
DIGITAL OUT (T-H300DAB)
w
DIGITAL IN (decoder, CD-R, MD, etc.)
Power cord (AC)
Be sure to connect the power cord to an AC outlet
which supplies the correct voltage.
Hold the power plug when plugging or unplugging
the power cord.
C
B
A
REMOTE CONTROL jack
If you have TEAC Reference 300 series, Convenient
sysytem control operations are possible.
<
By pressing the POWER STANDBY button of the
Reference 300 series Amplifier/Receiver, you can
switch ON/standby all the unit connected with
remote control cord.
<
When you press the PLAY button of the source, the
INPUT SELECTOR of the Reference 300 series
Amplifier/Receiver will be set to the source
automatically.
<
The source you select by the INPUT SELECTOR of
the Reference 300 series Amplifier/Receiver will
start playback automatically.
<
When you turn ON the system, the source that was
selected last time will start playback
automatically.
<
You can use the system remote control unit to
operate all the unit connected with remote control
cords.
Connect the remote control jack (A or B) of each
component with remote control cords.
D

Teac T-H300DAB Specifications

General

Brand	Teac
Model	T-H300DAB
Category	Tuner
Language	English