< If the T-R610 is connected to the A-R610 with a remote
control cord, you can switch ON/standby both the A-R610
and the T-R610 by pressing the STANDBY/ON button of the
A-R610.
Select AM or FM by pressing the BAND button.
2
Select the station you want to listen to (auto selection).
3
Selecting stations which cannot be tuned automatically
(manual selection)
When the TUNING button (‡ or °) is pressed momentarily,
the frequency changes by a fixed step.
Press the TUNING button (
‡ or °) repeatedly until the
station you want to listen to is found.
Hold down the TUNING button (
‡ or °) until the frequency
display begins to change. When a station is tuned in, the
tuning process will stop automatically.
< Press the TUNING button (‡ or °) to stop the auto
selection.
Stereo:
FM stereo broadcasts are received in stereo and the
“STEREO” indicator lights on the display.
Mono:
To compensate for weak FM stereo reception, select this
mode. Reception will now be forced monaural, reducing
unwanted noise.
FM MODE Button
Pressing this button alternates between Stereo mode and
Mono mode.
To Next Page
