a
MUTE
b
TUNING
j
(previous tuning button)
Hold down 2 or 3 seconds for auto selection of the previous channel.
c
TUNING
k
(next tuning button)
Hold down 2 or 3 seconds for auto selection of the next channel.
d
PRESET j
(previous station button)
e
PRESET
k
(next station button)
f
0-9
(number buttons)
g
RDS
Hold down 2 or 3 seconds for brightness adjustment.
h
MODE
i
FREQ
(frequency direct input)
j
MEMORY
k
BAND
(band switch button)
l
TUNER
(tuner switch button)
Note before using the remote control
Press the TUNER button to switch to the TUNER mode before o
operating the unit by using the remote control.
The effective range of the remote control is no greater than 10m o
and an angle no greater than 30 degrees.
Buttons that are not listed or mentioned in the remote control o
diagram are not used for this unit. It is normal that there will be no
response when you press them.
Battery installation
1
Open the cover of the remote control unit.
2
Insert two AAA batteries. Make sure that the batteries are
inserted with their positive ¥ and negative ^ poles
positioned correctly.
3
Close the cover.
Identifying the Parts (remote control)
To Next Page
Loading...
