Teac V-5000 - MONITOR PERFORMANCE; Input Level Checks; Meter and Peak Level Monitoring; Special Input Performance

5-4 MONITOR PERFORMANCE
V-7000/V-5000
EAY—*R
Deck settings
Mode : RECORD/PAUSE AUTO MONITOR sw. : SOURCE
REC LEVEL control : Maximum DOLBY NR sw. OUT
BALANCE control : O(center)position MPX FILTER sw. OUT
ITEM SETTING INPUT SIGNAL
ok 3i-[>) Re AAES
7. Min. Line
input level
54 Vm \
AA LAID
Connection : Fig. 5-1
8. Specified
Line input
level
Line HEA
PLAID
Connection : Fig. 5-1
9. Meter level
XA-ILN
Ib
Connection : Fig. 5-1
Connection : Fig. 5-1
10.CD CHECK] Mode : STOP
CD CHECK button-on
11.CD DIREC
: input level | Connection : Fig. 5-1
CD DIRECT] CD DIRECT button-on
AAVAIDL
12.MPX- F.coil
MPX- F. 34]
13.Peak level
E-ILX
Connection : Fig, 5-1
MPX FILTER sw. -on
Connection : Fig. 5-1
MARGIN RESET button~on
W Adjust R channel same as L channnel.
Rie. RF ¥ VANS ARCA S.
14.PHONES
output level
PHONES
HALAL
Connection : Fig. 5-7
PHONES LEVEL control
: max.
ADJUST
(or CHECK)
VASE (PR
MEASURING POINT. REMARKS
RESULT ren
AUSEAEPA ° HS
LINE IN (L/R):
400Hz/- 19dB
(86.9mV)
OUTPUT (L/R)
~2dB + 3dB
(436mV~869mV)
Check
LINE IN (L/R) :
400HZ/-9dB (& BALANCE)
(275mV) control. ze
* Adjust the balance between the left and right channels by BALANCE control,
L-R chOUNJV#ld, BALANCED#E AIC CHIEFS
REC LEVEL | ouTpuT (L/R)
-2dB (615mV)
position)
ZAKS RECLEVEL & BALANCED ESAS E,
LINE IN (L/R):
400HZ//-9dB Check PEAK LEVEL meter (LR)
(275mV)
-1dB lit ; (00) mark
CD DIRECT IN(L/R):
PEAK LEVEL meter (L/R)
400Hz,//—21dB
|
Check
-1dB
lit
;
(O00)
mark
(69mV)
COUNTER
:
Indication ; “cdch”
OUTPUT (L/R)
-2dB + 2dB
(489mV~775mV)
CD DIRECT IN(L/R):
400Hz/ — 4dB
(489mV)
LINE IN (L/R) :
19kHZ/-9dB U105,/U205
(275mV)
LINE IN (L) :
R 17
400HZ/-3dB
Check
Check
OUTPUT (L/R)
PEAK LEVEL meter (L),(R)
(548mV) :
+5 dB lit
PHONES :
At each channel
Biv VRNE
-16dB + 3dB
(86.9mV~1738mV)
LINE IN (L/R):
400HZ/- 9dB
(275mV)
82 load
11