Teac W-4200 - Safety Instructions

SAFETY INSTRUCTIONS
CAUTION:
© Read all of these instructions.
© Save these instructions for later
use.
@ Follow all warnings and
instructions marked on the audio
equipment.
1.
6A.
Read Instructions - All the safety and
operating instructions should be read before
the appliance is operated.
Retain Instructions - The safety and operating
instructions should be retained for future
reference.
Heed Warnings - All warnings on the
appliance and in the operating instructions
should be adhered to,
Follow Instructions - All operating and use
instructions should be followed.
Water and Moisture - The appliance should
not be used near water - for example, near a
bathtub, washbowl, kitchen sink, laundry tub,
in a wet basement, or near a swimming pool,
etc.
Carts and Stands - The appliance should be
used only with a cart or stand that is
recommended by the manufacturer.
An appliance and cart combination should be
moved with care. Quick stops, excessive
force, and uneven surfaces may cause the
appliance and cart combination to overturn.
ese a
Wall or Ceiling Mounting - The applicance
should be mounted on a wall or ceiling only as
recommended by the manufacturer.
Ventilation - The appliance should be situated
so that its location or position does not
interfere with its proper ventilation. For
example, the appliance should not be situated
on a bed, sofa, rug, or similar surface that may
block the ventilation openings; or, placed in a
built-in installation, such as a bookcase or
cabinet that may impede the flow of air through
the ventilation openings.
9.
10.
1.
12.
13.
14,
15.
Heat - The appliance should be situated away
from heat sources such as radiators, heat
registers, stoves, or other appliances
(including amplifiers) that produce heat.
Power Sources - The appliance should be
connected to a power supply only of the type
described in the operating instructions or as
marked on the appliance.
Grounding or Polarization - Precautions
should be taken so that the grounding or
polarization of the appliance is not defeated.
Power-Cord Protection - Power-supply cords
should be routed so that they are not likely to
be walked on or pinched by items placed upon
or against them, paying particular attention to
cords at plugs, convenience receptacles, and
the point where they exit from the appliance.
Cleaning - The appliance should be cleaned
only as recommended by the manufacturer.
Power Lines - An outdoor antenna should be
located away from power lines.
Outdoor Antenna Grounding - If an outside
antenna is connected to the receiver, be sure
the antenna system is grounded so as to
provide some protection against voltage
surges and built up static charges. Section 810
of the National Electrical Code, ANSI/NFPA No.
70 - 1984, provides information with respect to
proper grounding of the mast and supporting
structure, grounding of the lead-in wire to an
antenna discharge unit, size of grounding
conductors, location of antenna-discharge
unit, connection to grounding electrodes, and
requirements for the grounding electrode. See
Figure below.
EXAMPLE OF ANTENNA GROUNDING.
‘48 PER NATIONAL
ELECTRICAL CODE
Gee SechGn"s o-20)
uno. conbuctons
uM e1aMes
feamen semgce,enovnowe
bone
EE net ao, Pak)
NEC ~ narowa execrmcat CODE