Teac W-480C - Safety Instructions

SAFETY INSTRUCTIONS
a a ST
CAUTION: 9. Heat - The appliance should be situated away
© Read all of these instructions. from heat sources such as radiators, heat
: if registers, stoves, or other appliances
e Save these instructions for later (including amplifiers) that produce heat.
use. 7 10. Power Sources - The appliance should be
@
Follow
all
warnings
and
connected
to
a
power
supply
only
of
the
type
instructions marked on the audio described in the operating instructions or as
equipment. marked on the appliance.
1.
Read
Instructions
-
All
the
safety
and
11.
Grounding
or
Polarization
-
Precautions
operating
instructions
should
be
read
before
should
be
taken
so
that
the
grounding
or
*
the
appliance
is
operated.
polarization
of
the
appliance
is
not
defeated.
2.
Retain
Instructions
-
The
safety
and
operating
12.
Power-Cord
Protection
-
Power-supply
cords
instructions should be retained for future
should be routed so that they are not likely to
reference.
be walked on or pinched by items placed upon
or against them, paying particular attention to
cords at plugs, convenience receptacles, and
the point where they exit from the appliance.
3. Heed Warnings - All warnings on the
appliance and in the operating instructions
should be adhered to.
13. Cleaning - The appliance should be cleaned
4. Follow Instructions - All operating and use
i 9 only as recommended by the manufacturer.
instructions should be followed.
14. Power Lines - An outdoor antenna should be
5. Water and Moisture - The appliance should :
located away from power lines.
not be used near water - for example, near a
bathtub, washbowl, kitchen sink, laundry tub, 15. Outdoor. Antenna Grounding - If an outside
in a wet basement, or near a swimming pool, antenna is connected to the receiver, be sure
etc.
the antenna system is grounded so as to
provide some protection against voltage
surges and built up static charges. Section 810
of the National Electrical Code, ANSI/NFPA No.
70 - 1984, provides information with respect to
proper grounding of the mast and supporting
structure, grounding of the lead-in wire to an
antenna discharge unit, size of grounding
conductors, location of antenna-discharge
unit, connection to grounding electrodes, and
requirements for the grounding electrode. See
Figure below.
6. Carts and Stands - The appliance should be
used only with a cart or stand that is
recommended by the manufacturer.
6A. An appliance and cart combination should be
moved with care. Quick stops, excessive
force, and uneven surfaces may cause the
appliance and cart combination to overturn.
EXAMPLE OF ANTENNA GROUNDING.
AS PER NATIONAL
ELECTRICAL CODE
7. Wall or Ceiling Mounting - The applicance
should be mounted on a wall or ceiling only as
recommended by the manufacturer.
TENNA i ani
jo LeaD WN
WIRE
8. Ventilation - The appliance should be situated
so that its location or position does not
interfere with its proper ventilation. For
example, the appliance should not be situated
on a bed, sofa, rug, or similar surface that may
block the ventilation openings; or, placed in a
built-in installation, such as a bookcase or
cabinet that may impede the flow of air through
the ventilation openings.
_]- ANTENNA,
DISCHARGE UNIT
(NEC SECTION 810-20)
GROUNDING CONDUCTORS
(NEC SECION 810-21)
=~ GROUND CLAMPS
1 POWER SERVICE GROUNDING
7 ELECTRODE SYSTEM
(NEC ART 260, PART H)
NEC — NATIONAL ELECTRICAL CODE