Teac W-520R - Loading a Cassette Tape

OPERATIONS
Loading a Cassette Tape
1 Use your finger or a pencil to turn
the cassette's hub and take up
any slack tape.
Note: Avoid touching the tape.
Fingerprints attract dust
and dirt.
0): * Notes:
SAI. e@ The cassette holder cannot be
IZ opened during recording or
playback.
@ If the power has been switched off
during play or recording, ejecting
2 Press the eject button (4)* to the cassette may be impossible.
open the cassette compartment In such a case, switch the power
door. on and press the eject button
3
Load
the
cassette
tape
with
its
again.
open
edge
facing
down.
4 Gently close the compartment
door
Tape Travel Depending on Setting of REV MODE Switch
Setting Tape Travel
Beginning Side B End Stop Start
— PPE EES REE res =a
=_—
Start Stop End Side A Beginning
When the tape reaches the end, playback or recording is released.
Beginning
we
@
End
®
During
forward
play
or
recording,
when
the
end
of
tape
ss is reached, the direction of tape running is reversed to
Stop play or record in the opposite direction. Reverse play
= D start or recording will continue to the end of the other side,
at which point play or recording is released.
End Beginning @® During reverse play or recording, when the tape
Side A reaches the end, play or recording is released.
PLAY mode (Tapes loaded in TAPE | or Il)
Side B ! ,
Beginning End During either forward or reverse play, when the end of
tape is reached, the direction of tape running is reversed
and play continues in the opposite direction. In this way,
the two sides of the tape are played back continuously;
End Beginning the tape will stop after 5 cycles.
Side A
C=) | PLAY mode (Tapes loaded in TAPE | and I!) |
— CONT PLAY (Continuous Playback) — Refer to "Continuous Playback Operation" chart on
page 9.
RECORD mode (TAPE II only) |
so Side B
Beginning End
——— >
Stop . ¥
Ce © Operation is same as =>.
Start
End Beginning
Side A