Teac W-700R - Page 3

PRECAUTIONS
Environment
Avoid using the deck in the following conditions:
e At high temperatures (near a heater, exposed to
direct sunlight, etc.).
e At extremely low temperatures.
e Where there is excessive humidity.
@ In a dusty atmosphere.
e@ Where power line voltage fluctuations are severe
(in which case the use of a voltage regulator may
be advisable).
Cassette Tape
Tape Selection:
For the automatic tape select function to work
properly, metal and chrome (cobalt) tapes must have
identification holes.
CEA
S ZEEE S
gq se S
e Tape position identification holes.
Normal Tapes
Chrome (Cobalt)
Tapes
Metal Tapes
Voltage Conversion
(General export models only)
Be sure to remove the power cord from the AC outlet
before repositioning the voltage converter switch.
1. Locate the voltage selector on the rear panel.
2. Using a flat-bladed screwdriver, set to the
appropriate 230 V or 120 V position according to
your area.
VOLTAGE SELECTOR
230V 120V
—S —&s er
o_]
Tape Handling:
Do not store tapes in the following places:
© On top of heaters, exposed to direct sunlight or in
any other places with high temperatures.
® Near speakers, on TV sets or amplifiers or where
they would be exposed to strong magnetic fields.
Where humidity is high and in dirty, dusty places.
Avoid dropping or subjecting cassettes to
excessive shocks.
As C-120 tapes are physically weak and could
become entangled in the transport mechanism, do
not use them.
IMPORTANT (for U.K. Customers)
The wires in this mains lead are coloured in
accordance with the following code:
BLUE: NEUTRAL
BROWN: LIVE
As the colours of the wires in the mains lead of
this apparatus may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows:
The wire which is coloured BLUE must be
connected to the terminal which is marked with
the letter N or coloured BLACK. The wire which
is coloured BROWN, must be connected to the
terminal which is marked with the letter L or
coloured RED.
In the U.K., this unit is sold without an AC
plug.
THE APPLIANCE CONFORMS WITH EEC
DIRECTIVE 87/308/EEC REGARDING INTER-
FERENCE SUPPRESSION
Dolby noise reduction and HX Pro headroom
extension manufactured under license from Dolby
Laboratories Licensing Corporation. HX Pro
originated by Bang & Olufsen.
"DOLBY", the double-D symbol DO and "HX
PRO" are trademarks of Dolby Laboratories
Licensing Corporation.