Teac W-700R - Loading a Cassette Tape

OPERATIONS
Loading a Cassette Tape
1 Use your finger or a pencil to turn * Notes:
the cassette's hub and take up e The cassette holder cannot be
any slack tape. opened during recording or
Note: Avoid touching the tape. playback.
Fingerprints attract dust ® If the power has been switched off
and dirt. during play or recording, ejecting
Press the eject button (4)* to the cassette may be impossible.
open the cassette compartment In such a case, switch the power
door. on and press the eject button
Load the cassette tape with its again.
open edge facing down.
Gently close’ the compartment
door.
Tape Travel Depending on Setting of REV MODE Switch
Setting Tape Travel
Beginning Side B End Stop Start
a ai a Foe ees se a
ae .
Start Stop End Side A Beginning
@ During forward play or recording, when the end of tape
is reached, the direction of tape running is reversed to
play or record in the opposite direction. Reverse play
or recording will continue to the end of the other side,
at which point play or recording is released.
End Beginning @® During reverse play or recording, when the tape
reaches the end, play or recording is released.
Side B A ,
Beginning End During either forward or reverse play, when the end of
tape is reached, the direction of tape running is reversed
and play continues in the opposite direction. In this way,
the two sides of the tape are played back continuously;
the tape will stop after 5 cycles.
End inni
Side A scceai
C= | PLAY mode (Tapes loaded in TAPE | and Il)
— CONT PLAY (Continuous Playback) — Refer to "Continuous Playback Operation" chart on
page 9.
RECORD mode (TAPE II only)
eho Side B
Beginning End
=
Stop . i
Start @ Operation is same as =>.
Start
End Beginning
Side A