Teac W-700R - Continuous Playback

Playback with TAPE | or TAPE II
1. Press the POWER switch to ON.
POWER
=e)
2. Set the REV MODE switch to the required tape
travel mode, referring to the chart “Tape Travel
Depending on Setting of REV MODE Switch" on
page 7.
REV MODE
—, — fos]
|
)
1
CONT PLAY
3. Load a pre-recorded cassette in TAPE | or Il.
4. Select the appropriate DOLBY NR system.
DOLBY NR
OFF OOB8 ooc
|
)
5. Press the <4 or B® button for TAPE | or II to start
playback.
6. Adjust the volume with the amplifier's volume
control.
® To stop playback, press the STOP button.
Continuous Playback
1. Load pre-recorded cassettes in TAPE | and TAPE
Il.
2. Set the necessary controls and switches but not
the <4 or & button, referring to "Playback with
TAPE | or TAPE II" on the left.
3. Set the REV MODE switch to the CONT PLAY
(C=) position.
REV MODE
i}
CONT PLAY
4. Press the <@ or B® button of the deck to be
played back first.
5. Tapes will be played back continuously,
according to the chart on page 9.
e To stop continuous play before 5 cycles have
been completed, press the STOP button of either
deck.
Multi-Counter
Tape Counter Mode
In this mode, the counter functions as a
conventional tape counter, counting up when the
tape is moving forward and down when the tape is
being rewound. The display can be cleared by
pressing the COUNTER CLEAR button, which resets
the counter index to "0000".
)
(== aia
=——-
aca
<a
fies
eet