Service Instructions
For your safety, service must be performed by qualified / authorized service personnel only.
Glass Information
1. Under no circumstances should this product be operated with a broken or chipped glass panel.
2. Do not strike or slam the glass.
3. Do not use abrasive cleansers to clean the glass.
4. This product uses tempered glass. Replacement of the glass supplied by the manufacture should only be
performed by authorized service personnel.
Operating Instructions
After reading these instructions, confirm that all controls on the heater are in the off position. Plug the heater
i
nto a 10 amp 110 volt outlet.
All controls and switches are on the front panel of the heater located inside the right hand door.
REMOTE CONTROL
Memory switch only works when the main power is on.
This function will store the current setting when the unit is turned off and
will recover setting when pressed again.
When the memory is switched OFF, it will cancel the Timing Shut Down
setting and the brightness level will recover to “5”.
Press “/\”adjusts the brightness level higher.
Press “\/” adjusts the brightness level lower.
Full bright----High bright—Medium—Low bright--Tiny bright
Press “/\” adjusts the temperature level higher.
Press “\/” adjusts the temperature level lower.
60
℃（
99
℉）
→30
℃（
86
℉）
→28
℃（
82
℉）
→26
℃（
78
℉）
→24
℃（
75
℉）
→22
℃
（
71
℉）
→OFF.
（
Cycle
）
Switch ON or OFF the Down light, Down light composed by 2 pcs
LED light board. Only for ON/OFF
Set the off time, time range: No setting –10 (cycle)
→1
0→20→30→40→50→1H→2H→3H→4H →5H→6H→7H→8H→9H (cycle)
Control Panel Buttons:
To Next Page
Loading...