IMPORTANT SAFETY TIPS
Alarm siren is VERY loud; NEVER place the unit close to ears.
Install the unit high enough to be out of reach of children 54″ or higher is recommended.
Keep this manual for future reference.
The Safe Pool can provide valuable protection when used correctly. However, it cannot guarantee complete
protection against accidents or injuries. Therefore, Techko cannot be held responsible for any loss, damage, or injury
that may occur.
INSTALLATION
WARNING: Read all installation and operation instructions thoroughly before proceeding with installation. Note: Not
all parts included are needed for installation. Please read the different mounting instructions to see what is needed
for your specific application
INSTALLING THE BATTERY:
1. When testing, before installing the battery, use a rubber band to temporarily secure the two magnetic sensors
together with the arrows pointing toward each other to avoid setting off the alarm unintentionally. During the
actual installation of the alarm, it’s best to install the battery after it’s mounted to avoid the alarm going off
unintentionally.
2. Remove the battery cover of the unit and install a new 9 Volt battery. Replace cover. (See Fig. 2)
3. If you are sensitive to loud sound, please wear ear protection against the loud alarm siren before testing the
alarm.
4. Once the battery is connected, the unit is now ON and working. To test the alarm siren, make sure you have ear
protection before testing. After ear protection is in place, separate the magnetic sensors apart by more than 12
inch. The alarm should sound immediately after the sensors are separated. Press the BYPASS button and
immediately secure the two magnet sensors together again to avoid the alarm sounding off unintentionally.
LED LIGHT WARNINGS
1. When the battery becomes low in charge or the volume becomes weak, the LED light will illuminate. The 9 volt
battery must be replaced.
2. Upon battery installation, the unit will beep once and the LED light will flash 10 times as it prepares to become
armed.
3. When a bypass button is pushed, the LED light illuminates to indicate acknowledgement to PASS through.
4. After the bypass button is pushed in and released, the LED light will flash 10 times to allow pass through and to
prepare the unit to become armed again.
To Next Page
Loading...