in the same direction. Note: Wooden gates do not require the sensor housings.
MOUNTING OUTDOORS ON METAL GATES
Using the provided zip ties, attach the alarm body to the metal gate frame. (See Fig. 6) Using a small flat head
screwdriver, gently pry open the recessed sensor spacer of the sensor housing(fig 6). Make sure that the arrows of
each sensor are pointed in the same direction as the sensor housing before placing the magnetic sensors inside the
sensor housing. Note: Metal gates may interfere with the magnetic sensor function. Use spacers provided to ensure
sensors operate properly. Secure the sensors using the zip ties onto the gate frame. Make sure that the sensors’
arrows are pointed towards each other and that the sensors are less than 1/2 inch apart.
MAINTENANCE
When the alarm volume becomes low, or the unit does not produce normal alarm sound, the red light will illuminate,
you must replace the 9-volt battery.
The Safe Pool’s plastic parts resists ultraviolet rays from direct sunlight exposure. However, slight discoloration over
time is normal.
WARNING!
THE SAFE POOL ALARM IS EXTREMELY LOUD WHEN ACTIVATED. FOR YOUR SAFETY, NEVER PLACE THE
UNIT CLOSE TO YOUR EARS. TO TEST THE ALARM, ALWAYS USE EAR PROTECTION AND DIRECT THE
UNIT AWAY BEFORE TESTING/ACTIVATING THE ALARM.
IT IS PROHIBITED BY LAW TO REMOVE THE INSTALLED ALARM AFTER IT HAS PASSED INSPECTION !
Important Warranty Information: A dated proof of purchase is required for warranty service
Customer Service: 1-888-8TECHKO(1-888-883-2456) Website: www.techkomaid.com
Mfg. By TECHKO 11 Marconi Street,
Irvine, CA
92618 MAID IN CHINA
To Next Page
Loading...