Note:
The camera is not equipped with built-in memory. Insert a pre-
formatted memory card before use.
Format MicroSD card with max. 32GB to FAT32. Normally
MicroSD cards are formatted when you buy them.
Long press (2 seconds) the ON/OFF button, the indicator
light turns BLUE. Device is turned on and waits for mode to be
chosen.
To turn off: Long press the ON/OFF button for 5 seconds the
indicator light turns off. The device is powered off.
The correct positioning of the camera is to have the
ON/OFF button always on the top. The video and photo recordings
have the correct orientation.
Modus (indicator lights)
LED Meaning
RED & BLUE light flash rapidly for 5
seconds and device shuts down
low battery power
no memory card
RED light flashes charging
RED light always on with charging
cable inserted
fully charged
BLUE light Video mode
RED light Photo mode
RED & BLUE light Motion detection
Settings
Camera settings (time stamp, resolution, lag of 5–60 seconds) are
done with a file which is saved to the MicroSD card. This should be
done before using the device.
Time Modification
Turn on the camera. The BLUE LED turns on. Meanwhile was a
text file created on the MicroSD.
To Next Page
Loading...
Need help?
General
