Video files will save a video every 5 minutes. The video file will be
saved sequentially until the memory is full. When the memory is full
the loop function will delete the oldest file and saves the newest.
To change the mode press the M button. To power off the device
hold and press ON/OFF button for 5 seconds.
Night vision LEDs
The infrared night vision light turns automatically on in dark
environment.
Check the file on the computer
Connect the Micro USB cable** (**included) to the computer and
device. Either mass storage will open by itself or you have to open
it manually. View the stored video/snapshot files. If the camera has
not powered itself up while inserting the Micro USB cable, turn the
camera on. Press ON/OFF button once.
Now you will see two folders, image folder and video folder.
Choose any folders to check the corresponding files.
Warnings
The device is not waterproof.
Do not attempt to disassemble the device, it may result in short-
circuit or even damage.
Do not drop or shake the device, it may break internal circuit
boards or mechanics.
Keep the device in dry and ventilated environment, avoid high
humidity and high temperature. Also batteries should not be
exposed to excessive heat or direct sunlight.
The device will be hot after using for too long time. This is
normal.
Use the accessory provided by our factory.
Keep the device away from children.
To Previous Page
Loading...
Need help?
General
