Technaxx TX-171

7
Insert the license plate in the holder
The following drawings show in sequence the insertion of the
license plate.
1. Step
→ Slide the license plate into the upper
opening.
→→ Press the license plate towards
the holder.
2. Step
→→→ Slide the license plate down
until it stops.
Camera angle adjustment
Set the camera at an angle where you
have a good view to the rear, depending on
the height of the license plate holder from
the ground.
Adjustable angle for flexibility: 75°
The displayed lines on the Smartphone give you an indication of the
distance. Definitely control the distance with a folding ruler.
Then tighten the screws on both sides of the camera
→Explanations for the installation of the Smartphone APP can be
found on the following pages.