Techness RUN 200 TOUCH - Treadmill Maintenance

82
C: Transformer defective Change the transformer
D: Controller defective Change the controller
E2
A: Motor wire or motor defective
Change the motor wire or change the
motor
B: The connecting wire between
the motor and controller is loose
or controller defective
properly connect the wire or change
the controller
E3
A : speed sensor not in place Re-connect the speed sensor
B: speed sensor defective Change the speed sensor
C: The connect wire between the
speed sensor and the controller
not in place
properly connect the wire ,
D: controller defective Change the controller
E5
A: Controller defective Change the controller
B: Motor defective Change the motor
E7
C: Computer can not test the
safety key signal
Check the safety key is in place.
No pulse
A:Handle pulse wire did not
disconnected or faulty
properly connect the wire or change
the wire
B: Console circuitry defective Change the console
Console
short of
display
A: The screw on the pcb is loose Tight the screw
B: Console defective Change the console
TREADMILL MAINTENANCE
Proper maintenance is very important to ensure a faultless and operational condition of the
treadmill. Improper maintenance can cause damage to the treadmill or shorten the life of the