AC Power Cord Connection
To connect the power cord to your
MM3000
simply plug female side of the power cord into the power
cord input which is on the rear of the
unit
. Then plug the male side of the power cord to an electric
outlet. The AC power cords supplied purposefully have 2 blades and one grounding prong. If your
outlet is not equipped to handle this type of plug, do not attempt to forcefully plug this AC power cord
into the outlet, and do not alter the plug so that it can fit in the outlet. The only course of action you
can take is to find another outlet which is properly equipped to handle a grounded plug or have an
electrician upgrade your electrical outlet. Be sure that the plug is well connected so that it does not
disconnect in the middle of usage. If at any point in time the supplied AC power cord is punctured or
damaged, replace it with a new power cord from a local electrician.
NOTE: ONLY PLUG IN THE AC POWER CORD WHILE THE UNIT’S POWER IS OFF AND THE
VOLUME IS TURNED DOWN. TURNING ON THE UNIT WITH THE VOLUME TURNED UP MAY
CAUSE THE UNIT OR ANY SPEAKERS CONNECTED TO IT TO BE DAMAGED. ALWAYS TURN
DOWN THE VOLUME PRIOR TO TURNING OFF THE UNIT.
The MM3000 is designed to power up to two groups of full-range passive loudspeakers. The speakers should
be connected via the speaker wire outputs on the rear of the MM3000.
Connecting the MM3000 to Passive Loudspeakers
Input / Output Connections
Connecting the Signal Source to the MM3000(DVD/MIXER/MP3 etc.)
NOTE: BE SURE NOT TO CONNECT AN AMPLIFIER OR ANY AMPLIFIER SIGNAL INTO THE RCA INPUT
JACKS. AS THIS COULD DAMAGE THE MM3000. NO OTHER AMPLIFIER IS NEEDED TO POWER YOUR
SIGNAL IN ADDITION TO THE MM3000. ALWAYS MAKE SURE THAT THERE IS ONLY ONE AMPLIFIER
IN THE SIGNAL PATH.
There are also input jacks for USB flash drive and SD card on the front panel of the MM3000. Just plug the
USB flash driver,SD card or iPod™(Classic and Nano) into their respective input jacks and set the
MM3000 to the corresponding input. Be sure that the volume of the MM3000
are turned down at first and
then slowly raise the volume to prevent damage the speakers or any of your other equipment.
The
unit
has two RCA input jacks on the rear of the unit which is designed to receive the signal directly
from your CD, mixer or any of your other sources.To ensure that you have correctly connected your CD
player (other sound sources) to the unit, make sure that the CD player has a RCA cord coming from
its output and that this cord is plugging into the RCA Input on the rear of the MM3000.
NOTE: WHEN MAKING THESE CONNECTIONS THE POWER OF THE
MM3000
AND THE SIGNAL SOURCE
SHOULD ALL BE IN THE OFF POSITION WITH THE VOLUME LEVELS TURNED DOWN.
ONCE THE UNITS
ARE ALL POWERED ON, SLOWLY INCREASE THE VOLUME TO AVOID DAMAGING ANY OF YOUR
EQUIPMENT. THE
MM3000
OPERATE MOST EFFICIENTLY WHEN USED WITH 8 OHM SPEAKERS.
Power Cord, MP3 Cable, FM Antenna, User Manual, Warranty, EQ Plug, Giveaway Card.
Accessories
MM3000
iPod™ & iPhone™ are registered trademarks of Apple Computers, Inc. Apple Computers, Inc. is not endorsing, sponsoring, or otherwise affiliated with this manufacturer.
To Next Page
Loading...
Need help?
General
