Technicolor DCI401 - Remote Controls TV, Not Volume; Digital Adapter Fails to Power On; Difficulty Programming TV Remote; VCR Recording Channel Mismatch

25
If the remote is turning the TV o and on and changing the
channels but not changing the volume:
• Your TV volume may have been turned all the way down or muted with the
old TV remote. .
If your Digital Adapter is not coming on:
• Makesurethatthepowercordissecurelyconnectedtothebackofthe
Digital Adapter.
• MakesurethattheDigitalAdapterpowercordispluggedintoaworking
power outlet.
If you cannot get the Digital Adapter remote programmed to
your TV:
• Youmaynotbeholding“POWER”longenough(upto2minutes).
• Besuretoreleasethe“POWER”buttonwithin2secondsonceyourTV
turnso.
VCR is not recording the right channel:
• TheVCRwillonlyrecordthechannelthattheDigitalAdapteristunedto.
SetyourTVandVCRtotheproperchannel(Ch 3 or Ch 4), then use the
Digital Adapter remote to tune the Digital Adapter to the channel to be
recorded.
3698674A final4 25 10/5/11 4:38 PM