Technicolor MediaAccess TG589vn - Page 92

86
9 INTERNET SECUR
ITY
DMS-CTC-20110713-0024 v1.0
 The Source Interface and IP Address (range).
Or you can type a User-defined IP address (range).
 The Destination Interface and IP Address (range)
Or you can type a User-defined IP address (range).
 The Service type of the traffic; this can be a protocol (DNS, SMTP,...) or a specific MediaAccess Gateway system
service.
8 Select an Action that should be done on traffic for which the firewall rules applies:
 Accept: to allow the traffic to pass
 Deny: to drop the traffic (without notification)
 Count: to let the traffic pass, but count it (Hits)
9Click Apply.
Use Any as IP address in case all traffic for the interface should be parsed.
Use Any as IP address in case all traffic for the interface should be parsed.