Technicolor MediaAccess TG589vn - Powering on the Mediaaccess Gateway

22
3 MANUAL INSTAL
LATION
DMS-CTC-20110713-0024 v1.0
3.2 Powering on the MediaAccess Gateway
Procedure
Proceed as follows:
1 Connect the power cord to the power port of the MediaAccess Gateway.
2 Plug the other end of the power cord into an electrical outlet.
3 Press the power button to turn on the MediaAccess Gateway.
4 Wait at least two minutes to allow the MediaAccess Gateway to complete the start up phase.