25
2 MANUAL INSTALLATION
DMS-CTC-20111123-0002 v1.0
mode
The automatic (default) or manual selection of the mobile operator and technology.
operator
This parameter can be used to fill in the Location Area Identifier. This code consists of a three-digit Mobile Country
Code (MCC) and a two-digit Mobile Network Code (MNC). For a list of all available Location Area Identifiers, please
refer to http://www.itu.int/dms_pub/itu-t/opb/sp/T-SP-E.212B-2010-PDF-E.pdf
.
technology
The initial radio access technology (2G / 3G) to use for connection. If the selected technology is not available, the
alternative will be used.
initcommand
The AT command to be executed between SIM verification and the actual network connection. This command can be
used to perform vendor specific actions that are required for a successful connection.
Example:
To check all your mobile connection configurations, use the following command:
Step 4: Attach the mobile interface
Execute the following command:
With the following parameters:
intf
The name of the mobile USB interface.
Example:
It is advised to select manual mode and fill in the mobile operator and technology.
Your mobile interface can only be configured if it is not attached.
:mobile ifconfig intf=mobile_usb pin=1234 apn=web.provider.com operator=20610 technology=3G
mode=manual puk=12345678 initcommand=ATE
=>:mobile iflist
mobile_usb:
pin: ****
puk:
APN: web.provider.com
mode: automatic
operator: 0
technology: 3G
init command:
=>
To check the configuration of a specific mobile connection use the command mobile iflist intf=<your
intf>.
:mobile ifattach intf=<string>
:mobile ifattach intf=mobile_usb
With the command mobile ifdetach intf=<string> you can detach a mobile USB interface.
To Next Page
Loading...
Need help?
General
