39
3 CONFIGURATION TOOLS
DMS-CTC-20111123-0002 v1.0
3.3 The Command Line Interface (CLI)
Introduction
The CLI allows you to perform a command-based configuration of the MediaAccess Gateway:
Accessing the CLI
Users can access the Command Line Interface:
From the a local network or the Internet via:
A Telnet session
For more information, see “3.3.1 Access the CLI via Telnet” on page 40.
The MediaAccess Gateway GUI
For more information, see “3.3.3 Access the CLI from the GUI” on page 43.
Via serial connection to the Console interface.
For more information, see “3.3.2 Access the CLI via a Console Connection” on page 41.
The CLI is intended for advanced users only!
To Next Page
Loading...
Need help?
General
