4. If you wish to connect a device hardwired, you will need to use the Yellow Ethernet
Lead provided with the router and connect it to one of the 4 ETH ports available.
5. Once all of the cables have been connected, you are now able to switch on the power
on the router, leave the router for 10-15 minutes and once all of the lights are on like
shown below, you are able to start using your broadband with Call Flow.
1. The
port labelled WAN should only
be used for the connection to the IDU.
2. It is recommended that for your main computer
you use the main Ethernet port which is labelled ETH1.
To Previous Page
Loading...
