EasyManuals Logo

Technics EAH-AZ40 Operating Instructions

Technics EAH-AZ40
37 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
Operation
22
Making a phone call
With Bluetooth
®
enabled phones (cell phones or smartphones) that support the “HSP” or “HFP” Bluetooth
®
profile, you can use the unit for phone calls.
HSP (Headset Profile):
This profile can be used to receive monaural sounds and establish two-way communication using the
microphone on the unit.
HFP (Hands-Free Profile):
In addition to the HSP functions, this profile has the incoming and outgoing calls function.
(This unit does not have a function that allows you to make phone calls independently of a Bluetooth
®
enabled
phone.)
1 Connect the Bluetooth
®
device and the unit. (l 19, “Connecting a Bluetooth
®
device”)
2 Touch a touch sensor (L or R) on the earphone once to answer an incoming call.
During an incoming call, ringtone will sound from the unit and the earphone LEDs will blink.
(HFP only) To reject a phone call, touch and hold a touch sensor (L or R) for about 2 seconds.
3 Start talking.
The earphone LEDs will repeatedly blink 2 times during a call.
To mute the voice during a call, touch the touch sensor (R) twice.
(To cancel muting, touch the touch sensor (R) twice again while muting.)
To switch the noise level of the other party during a call, touch the touch sensor (R) 3 times.
Voices will be easier to hear when you reduce the audio noise from the other party.
This function is effective in reducing the noise heard from continuous sources (ventilation fans, etc.) in the
vicinity of the other party.
The volume can be adjusted during a phone call.
For operating procedures (
l 26, “Operating with the touch sensors”)
4 Touch and hold an earphone touch sensor (L or R) for about 2 seconds to end the call.
Note
There may be instances when hands free setting needs to be done on the Bluetooth
®
enabled phone.
Depending on the Bluetooth
®
enabled phone, you may hear incoming and outgoing call ringtones of the phone from
the unit.
You can have the Bluetooth
®
enabled phone make phone calls by using the microphone of the unit and an app of the
Bluetooth
®
enabled phone. (l 24, “Activating voice functions”)
eah_az60_az40_pnqp1675za_full_eng_s.book 22 ペー 2021年9月28日 火曜日 午前10時7分

Other manuals for Technics EAH-AZ40

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Technics EAH-AZ40 and is the answer not in the manual?

Technics EAH-AZ40 Specifications

General IconGeneral
Control typeTouch
Headset typeBinaural
Product typeHeadset
Product colorBlack
Wearing styleIn-ear
Recommended usageCalls/Music
Protection featuresWater resistant
International Protection (IP) codeIPX4
Ear padsYes
Eartips materialSilicone
Charging case typeWired
Charging case connector typeUSB Type-C
Connectivity technologyTrue Wireless Stereo (TWS)
Ear couplingIntraaural
Microphone typeBuilt-in
Battery life330 min
Weight and Dimensions IconWeight and Dimensions
Depth24 mm
Width22 mm
Height26 mm
Weight5 g
Charging case weight30 g

Related product manuals