EasyManuals Logo

Technics EAH-AZ40 Operating Instructions

Technics EAH-AZ40
37 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #26 background imageLoading...
Page #26 background image
Operation
26
Operating with the touch sensors
You can operate the touch sensors on the earphones to change to the Bluetooth
®
pairing mode, or remote
control the Bluetooth
®
device.
Depending on the Bluetooth
®
device or the app, even if you operate the touch sensors on the earphones, some
functions may not respond or may operate differently from the descriptions below.
List of operations available with the touch sensors
*1 To cancel muting, touch the touch sensor (R) twice again while muting.
*2 With both earphone LEDs (L and R) blinking alternately in blue and red
Note
You can change the functions assigned to the touch sensors on the “Technics Audio Connect” app (free of charge).
(Customization of touch sensor) (
l 18)
You can also use just one side of the earphones independently. In this case, it is only possible to perform operations
available on the side you are using.
A beep sounds to indicate that you have touched to reach either the maximum or minimum volume level.
Function Touch sensor (L) Touch sensor (R)
Listening to music
Playback/pause Touch once
Raise the volume Touch rapidly 3 times
Lower the volume Touch rapidly 2 times
Forward a track Touch rapidly 2 times
Back a track Touch rapidly 3 times
Making a phone call
Receive a phone call Touch once while receiving the call
Raise the volume Touch rapidly 3 times
Lower the volume Touch rapidly 2 times
Mute the voice of the call
*1
Touch rapidly 2 times during the
call
Switch the noise level heard
from the other party
Touch rapidly 3 times during the
call
Reject a phone call Touch and hold for about 2 seconds while receiving the call
End a phone call Touch and hold for about 2 seconds during the call
Change control of external
sounds
Touch and hold for about
2 seconds
Start the voice assistant Touch and hold for about
2 seconds
Set to the Bluetooth
®
pairing
mode
*2
(l 19, “Connecting a Bluetooth
®
device”)
Return to the factory settings (l 27, “Restoring to the factory settings”)
eah_az60_az40_pnqp1675za_full_eng_s.book 26 ペー 2021年9月28日 火曜日 午前10時7分

Other manuals for Technics EAH-AZ40

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Technics EAH-AZ40 and is the answer not in the manual?

Technics EAH-AZ40 Specifications

General IconGeneral
Control typeTouch
Headset typeBinaural
Product typeHeadset
Product colorBlack
Wearing styleIn-ear
Recommended usageCalls/Music
Protection featuresWater resistant
International Protection (IP) codeIPX4
Ear padsYes
Eartips materialSilicone
Charging case typeWired
Charging case connector typeUSB Type-C
Connectivity technologyTrue Wireless Stereo (TWS)
Ear couplingIntraaural
Microphone typeBuilt-in
Battery life330 min
Weight and Dimensions IconWeight and Dimensions
Depth24 mm
Width22 mm
Height26 mm
Weight5 g
Charging case weight30 g

Related product manuals