Technics Quartz SL-10 - Manual Play

@ Manual play
(Multi-function operation)
sta rt button
@ For normal and fast inward cueing
Refer to the Quick Reference Chart on Page 10 for more
about start and stop button operation.
Press the cueing button to raise the tonearm, then press the
start button to move the tonearm inward (toward the center
of the record).
The tonearm will keep moving inward as long as you keep
the start button depressed.
If you press the start button intermittently, the tonearm will
move inward in approximately 1 mm steps.
(A¢nnnen
repeat cueing start stop
~«
oa
When you release the start button, the tonearm will stop at
the position it has reached,
Press the cueing button again to lower the tonearm back
onto the record and begin play.
if you press the start button harder, the tonearm will move
inward faster.
stop button
@ For normal and fast outward cueing
The tonearm moves outward (towards the edge of the
record) as long as you keep pressing the stop button (after
raising the tonearm by. pressing the cueing button).
If you press the stop button intermittently, the tonearm will
move outward in approximately 1 mm steps.
Cranna oo
stop
a
col _
The tonearm will stop at the position it has reached when
you release the stop button.
When you press the cueing button again, the tonearm willbe
lowered onto the record and play will begin.
if you press the stop button harder, the tonearm will move
outward faster.
Note:
A safety feature of this unit is that the tonearm can only
be cued between the lead-in and lead-out grooves. There-
fore, you cannot cue the tonearm all the way back to the start
position at the edge of the platter in the case of 17 cm (7")
and 25 cm (10”) records. Instead, press the cueing button
once again to lower the tonearm onto the record, then press
the stop button.
repeat
@ For repeat play
Press the repeat button and the repeat indicator LED will
turn on to confirm that the record will be played again.
e To stop the repeat cycle, press the repeat button again.
e Pressing the stop button or stand-by switch will also stop
repeat operation.
repeat
= 2 |
ing
@ For raising or lowering the tonearm
during play
When you press the cueing button, the tonearm rises up
from the record surface.
The LED illuminator turns on when the stylus tip is not
in contact with the record grooves.
Press the cueing button again to lower the tonearm onto
the record surface and begin play again.
The LED illuminator will then turn off.
(*)
®)
cueing
—
a