Technics SC-CH700 - Cassette Tape Playback Procedures

I Listening to Tapes
^ Either tape deck 1 or tape deck 2 can be used for tape playback by
following the same steps.
(This page shows an example using deck 1.)
1
/
■ V
3 ■
)
Tommies
_1
U -i J
□
<
□ 1 1_?_Ld
1 >
n
-1 c„. H
D
-i— ■ 1
/
D
«- » -»
- DOUh
n
CZZD
COUNTER RESET
Have you switched on the power?
Step 4 can be operated using the remote control with the procedure
below.
1 P ress the eject button, and then insert the
cassette tape to be used for piayback.
1 teM01t£ 1
fo; Co) ;
;
p.... •• ;
.
.
Illuminates
•The part of the cassette tape where the tape is exposed
should face down-ward.
• Either normal, chrome or metal type cassette tape can be
used.
•To reset the tape counter (0000), press the counter reset
button.
•While the reverse side of the tape is being played back, the
counter will count back. (0000-9999-9998-)
2 P ress the reverse mode select button to se¬
lect the appropriate reverse mode.
Each time the reverse mode select button is pressed, one of
the three reverse mode indicators will be alternately displayed.
'T'*’ : One side only will be played, and then the tape will
automatically stop.
: Both sides will be played 8 times, and then the
tape will automatically stop.
OO ’ When a tape is loaded into only deck 1 or 2
Both sides (from forward side to reverse side) will
be played, then the tape will automatically stop.
When tapes are loaded into both decks
Both sides (from forward side to reverse side) of
the tape in deck 1 are played first, and then both
sides of the tape in deck 2.
After repeating above operation 8 times, the tape
will automatically stop.
3 P ress the Dolby noise reduction button to set
the Dolby NR mode B or C in which the tape
was recorded.
The Dolby noise reduction indicator (B or C) will illuminate.
If the tape was not recorded in a Dolby NR mode, press the
Dolby noise reduction button again and the Dolby NR indicator
will go out.
1 Rfladit 1 t
(o) (o) /
1
oo
. ►
Dolby noise reduction indicator
4 P ress the playback button to start playback.
I > I : The fonward side (front side) will be played.
I < I : The reverse side will be played.
r— LBEMsatj
^ PLAY*^
Co) Co)
ID
cc
>
..... ..... ...
►
Deck 1 remote indicator
•When operating from the remote control and the tapes are loaded
in both decks, press the deck 1/2 selector on the remote control to
select the deck to be used. The remote indicator will illuminate to
show which deck can be operated with the remote control.
•Tape direction can be reversed manually during playback by
pressing the opposite of the playback button.