Technics SC-CH700 User Manual

»Edit-Recording from Compact Discs
Up to 30 tracks can be edit-recorded. In any of the following edit-recording functions, you can record with
Use of the unit’s edit-recording functions safeguard against a break desired tone and effect.
in the continuity of the sound when the recording changes from one See "Creating Your Own Sound” on page 58-66.
side of the tape to the other (except “Fade-in edit recording").
5 43
Sequential editing
This function allows for automatic recording of compact disc tracks
sequence. At the end of each side of the tape, the song that will not
fit completely will be faded out, a song faded out on side "A” will be
recorded from the beginning on side "B".
During recording, silent gaps of approximately 4 seconds are in¬
serted between tracks automatically (auto space function).
A tape such as follows will be made;
Faded out at the end of side A-
(Side A) I 11st track I 12nd track!
Srd tracK
(SideB) I
track I I
15th track [ | 6th track | 17th
N
n
The track that has been faded Faded out if the tape ends
out at the end of side A in the middle of the track
Have you switched on the power?
1 L oad a tape in deck 2.
When making a Dolby NR recording, press the Dolby noise
reduction button to select "B" or “C”.
Recording will progress automatically from the forward side to
the reverse side of the tape, so insert the tape with the side
from which you intend to record first facing toward you, then
select the "W reverse mode.
2 Press the input seiect button marked “CD” on
the ampiifier.
3 Press the disc tray open/ciose button to load
a disc.
4 P ress the normai/tape length edit button once
to indicate “C-AUTO”.
The cassette deck will rewind the tape and then take up the
leader tape automatically and the “CD" edit indicator will
illuminate. The CCRT function (see page 42) will be automati¬
cally activated.
When you want to record programmed tracks, first program
tracks in memory using the program play procedure (see page
30) before pressing the normal/tape length edit button.
Edit Indicator
L.' I I T l l
5 P ress the play button.
The ATLS function (see page 51) will operate to adjust the
recording level, and then recording will start.
When edit-recording has finished, the cassette deck automat¬
ically enters the recording standby mode.
When the link indicator illuminates, it is possible to record
another disc on the tape leftover using the sequential editing
(see page 51). If another disc is not going to be recorded,
press the stop button on the CD player/tuner.
The CCRT function will active in the CD edit recording
mode. However, according to the types of the cassette tape,
the CCRT function may not activate correctly.
In this case, press the power “STANDBY^/ON” switch to
the standby mode, and replace the cassette tape. The
CCRT function also may not activate when the heads of the
cassette deck is dirty. (To clean the head, see page 73.)
Your attention is drawn to the fact that recording pre-recorded
tapes or discs on other published or broadcast material may
infringe copyright laws.
45

Technics SC-CH700 Specifications

General

Brand	Technics
Model	SC-CH700
Category	Stereo System
Language	English