Technics SC-CH700 User Manual

taking a Recording
2 4653 1
^ %
^ 1
TBchnics
/
/
-1
1 ( < 1
□ 1 > 1
rd
_J
□
r'l 1
^ I — h
■ n- -1 . -1-
, -, c:
b c-1-> J
D 1 ->
COUNTNMU' not*
L.EC.
To record the desired source
Although you can record a compact disc using the following proce¬
dure, it is recommended that you use the handy compact disc
edit-recording procedure. (See page 45-51.)
To make a tape-to-tape recording, see “Tape-to-Tape Recording”
on page 52.
Steps 5 and 6 can be operated using the remote control with the
procedure below.
1 Press the deck 2 eject button to load a tape in
deck 2.
You cannot record on the leader tape, so take up the leader
tape in advance.
2 When making a Dolby NR recording, press the
Dolby noise reduction button to illuminate the
Dolby NR indicator “B” or “C”.
3 Select the reverse mode using the reverse
mode select button.
One side will be recorded, then the tape will auto¬
matically stop.
; Both sides will be recorded (forward side-reverse
side), then the tape will automatically stop.
A When making a CCRT recording, press the
CCRT button to illuminate the CCRT indicator.
(See page 42.)
When the CCRT mode is activated, the test signal for adjust¬
ment will be recorded on the tape, so the previous recording
will be automatically erased.
ID
cV>
CCRT
MAS
LfVEL
EG
.••••
r~B£HOTe 1
;; ; (o; (o)
1-__z:
CCRT indicator will illuminate.
5 Press the record/record standby button to put
the cassette deck Into the recording standby
state, then press the input select button of the
source to be recorded.
The playback indicator will flash.
01 (50
CCRT
MAS
LEVEL
emu
-PL
onr 1
AY»^
al®)
_—
Recording indicator
6 Press one of the playback buttons to start
recording, then start playing the source to be
recorded.
I > I : When recording on either the forward side or both
sides
I I : When recording only on the reverse side
Notes;
• Do not press the input select buttons while the CCRT mode is
activated.
•To press the eject button in the power on condition after the CCRT
setting is completed makes the CCRT mode cancel.
•Do not press the disc tray open/close button while recording. It
releases the recording condition.
■ Synchro start function
When you make a recording from a compact disc, the recording will
automatically start when you press the play button on the compact
disc player section In the recording standby state.
After recording has been completed, the cassette deck will create a
non-recorded passage of about 4 seconds, and then go into the
recording standby state.
■ if the “-E-” indication is dispiayed on the cas¬
sette deck dispiay
An “-E-" will appear in tape counter if the cassette deck is not
ready to record because the safety tab has been broken off. Correct
the problem and then repeat the procedure from step 4.
41

Technics SC-CH700 Specifications

General

Brand	Technics
Model	SC-CH700
Category	Stereo System
Language	English