Technics SC-CH700 - Adjusting EQ Levels and Low-Frequency Emphasis

To adjust the level of the equalization
curves
The level of the pre-programmed equalization curves can be ad¬
justed in 7 steps using the sound effect level control. (After the
adjustment has been done, the pre-programmed equalization curve
itself cannot be affected.)
Have you switched on the power?
Is the SFP indicator in the off condition?
If the SFP indicator illuminates, press the SFP OFF/ON button to go
off the indicator before continuing.
This function can also be performed from the remote control. Follow
the procedure described below.
(White playing the desired source,)
1 Press the equalization ON/FLAT button to ON.
The equalizer on display will appear.
2 Press the fixed mode select button to select
the desired equalization curve.
3 Adjust the level of the equalization curve
using the sound effect level control.
: When increase the level
To emphasize low-frequency soun d
It is effective especially in a low volume level.
(While playing the desired source,)
Press the loudness button on the amplifier to illu¬
minate the loudness indicator.
LOUDNESS
To cancel, press this button again to go off the indicator.
(NO
* — ^ *
m « i« MS SIS Of » i.sa IMS sjs ms iss
i / n r n i
: When decrease the level
<Nn
S1A n MS MO SM a» IS 1JS SMS SJS MS MS
■ ■■ '
61