Technics SC-CH700 User Manual

Creating Your Own Sound (con,
To adjust the reverberation sound
effect
The reverberation sound of the surround sound ntodes (SFP) can
be adjusted using the sound effect level control.
(The pre-programmed surround sound itself cannot be affected
after the adjustment has been done.)
This function can also be performed from the remote control. Follow
the procedures described below.
(While playing the desired source,)
1 Press the SFP OFF/ON button to ON.
The SFP indicator will illuminate.
2 Press the fixed mode select button to select
the desired surround sound mode.
3 A djust the level using the sound effect level
control.
O
O
When increase the effect
When decrease the effect
The reverberation sound and the equalization curve are auto¬
matically adjusted at the same time.
The reverberation sound display
The reverberation sound can be adjusted within the range de¬
scribed below.
■ To adjust ths equalization curve after above
adjustment has been done
Press the Jog mode button to illuminate the equal¬
izer frequency indicator, and then proceed to the
step 1 on page 65.
EQFREQ
Note:
While the “USER” illuminates, the reverberation sound with
equalization effect can not be adjusted.
34

Technics SC-CH700 Specifications

General

Brand	Technics
Model	SC-CH700
Category	Stereo System
Language	English