Technics SC-CH700 - Page 8

Connections (continued)
Speaker cables
Match the two wires from the left and right speaker cables with the
same colored levers of the speaker terminals, then Insert the wires
Into the respective terminals.
First connect the cables to the speakers, then to the amplifier.
d) @; Push up on the lever. Insert the bare ends of the wires, and
push down the lever. (Refer to the right.)
©: Push down on the lever. Insert the bare ends of the wires,
and push up the lever. (Refer to the right.)
Note:
•Make sure the bare ends of the wires are not unraveled. (If they
are, twist them tight again.)
•Take care not to short the wires. (The main unit could be damaged
if they are shorted.)
CD player/tuner Sound processor
Push down on and hold the lever
while inserting the bare ends of
the wire.
8