Technics SC-EH600 User Manual

Setting the time
The tuner/amplifier displays the time, frequency and other
information on CDs and tapes.
This is a 24-hour display clock.
The figure shows how to set the time for 16:25.
H| Switch on the power.
Q © Press CLOCK/TIMER to show “CLOCK”.
Every time you press the button, the indication changes in
the order of CLOCK—*© PLAY-*© REC—»Original dis-
play.
Within 5 seconds:
© Press SET.
©Press TUNING (v or a) to set the present
time on the display.
The time display can be changed in one minute units by
tapping the buttons, and quickly by holding down the
buttons.
© Press SET.
The display will return to the previous display after about 3 sec¬
onds.
When appears:
It appears when you connect the AC power supply cord for the first
time or if there has been a power failure.
Reset the time as explained above.
If the minutes setting Is off:
1. Press CLOCK/TIMER.
2. Press SET.
3. Press TUNING (v or a ) to set the minutes, and then press SET.
To display the clock again:
Press CLOCK/TIMER.
The clock display will appear for about 5 seconds.
For your reference:
When you turn OFF the system from the POWER button, the system
goes on standby.
Demo function while the power is on:
When the input source is set to "CD" or "TAPE", the demo
function will run automatically after about 2 minutes in the
stop mode.
You can cancel the demo function by pressing and holding
DISP MODE/-DEMO for about 2 seconds while the auto¬
matic demo function is activated.

Technics SC-EH600 Specifications

General

Brand	Technics
Model	SC-EH600
Category	Stereo System
Language	English