Technics SC-EH600 - Recording from radio broadcasts

Preparation:
Advance the tape to a point from where recording can start im¬
mediately.
Switch on the power.
Press A OPEN on deck 2 and insert the tape
with the exposed part of the tape facing down¬
ward.
Close the holder.
To record in Dolby B NR;
Press DOLBY NR and check NR” is dis¬
played.
Fi Press REV MODE to select the reverse mode.
ZZ.: One side will record, and then the tape will stop automat¬
ically at the end of the tape.
ZZy. Both sides will record (forward side-* reverse side), and
then the tape will stop automatically at the end of the
tape.
C^ly. Same as above (When you press 9 REC PAUSE, "c^D"
will be automatically switched over to
jF} Tune in the desired station.
See page 15.
Press • REC PAUSE to put the cassette deck
into the recording standby mode.
REC PAUSE indicator will light.
The playback indicators <3 or t> will start flashing.
Q Press < or > to start recording.
£>: To begin recording from the forward side.
<: To begin recording from the reverse side.
!
ii
To stop recording:
Press ■ .
To display the tape counter while recording:
Press COUNTER DISPLAY.
The tape counter will be displayed for approximately 5 seconds. This
is a useful way for knowing what point of the tape you're at.
To cut an unnecessary part while recording:
1. Press# REC PAUSE.
The cassette deck will go into the recording standby state.
2. To resume recording, press <1 or t>, whichever playback indicator
is flashing.
Recording
operations