Technics SC-EH750

Using
the
seat
position
function
oH
This
function
lets
you
adjust
the
listening
position
for
better
effect.
With
SC-EH750,
this
mode
can
only
be
tumed
on
or
off
if
the
[SEAT
POSITION]
lamp
is
orange
(=
page
31).
The
mode
cannot
be
used
if
the
lamp
is
off.
With
SC-EHS550,
this
mode
can
only
be
used
when
Virtual
Dolby
Surround
is
on.
Ei Press [SEAT POSITION}.
The [SEAT POSITION] lamp flashes green.
While the indicator is flashing change the seat position,
Within 10 seconds
Adjust the seat position.
SC-EH550
DISPLAY MODE
To turn off the SEAT POSITION mode
Press
[SEAT
POSITION]
once
to
select
the
function
and
once
again
to turn it off while the lamp flashes.
With the remote controt
1. Press [AV EFFECT].
2,
Press
[4]
or
[>]
so
the
[SEAT
POSITION]
lamp
flashes.
3.
Press
[A}
(ON).
4.
Press
[4], [>],
['V],
or
[A]
to
adjust
the
seat
position.
To
turn
it
off,
after
steps
1
and
2,
press
[V]
(OFF).
(For SC-EHS50)
1.
Press
[SEAT
POSITION]
so
the
[SEAT
POSITION]
lamp
flashes,
2. Press [4] or [>] to adjust the seat position,
To
turn
it
off,
press
[SEAT
POSITION]
so
the
[SEAT
POSITION]
lamp
goes
out.
When
used
with
virtual
rear
surround
(SC-EH750
only),
seat
posi-
tion
is
changed
in
3
horizontal
steps.
With
SC-EH550,
seat
position
is
changed
in
5
horizontal
steps,
SEAT SEAT
POSITION POSITION
(On the tuner amplifier)
With
virtual
rear
surround
SC-EH550
MULT JOG
Sound field/tone quality operations/other functions
Concerning the display.
The
sound
processor
shows
the
level
of
each
sound
range
with
the
three types of display described below. E}
Press [DISPLAY MODE].
The spectrum display will change as foliows.
i] Normal display
This display indicates the strength of the sound in each tonal
range.
[2] Peak-hold display
The peak sound vaiue of each sound range is held on the dis-
play for about one second after it occurs.
3} Aurora display
The peak sound value of each sound range is displayed in in-
verted form.