etc. are used.
When replacing any of components, be sure to use only
manufacture's specified parts shown in the parts list.
Caution!
- Secondary trouble can be prevented by taking care during repair.
- IC and LSI are sensitive to static electricity.
- Cover the parts boxes made of plastics with aluminum foil.
- Ground the soldering iron.
- Put a conductive mat on the work table.
- Do not touch the legs of IC or LSI with the fingers directly.
- Voltage and signal lines
: Positive voltage line
: Negative voltage line
: Source signal line
9. Schematic Diagram
10. Printed Circuit Board Diagram
11. Block Diagram
12. Wiring Connection Diagram
13. Replacement Parts List
Notes:
* Important safety notice:
Components identified by mark have special characteristics
important for safety. / Furthermore, special parts which have
purposes of fire-retardant (resistors), high-quality sound
(capacitors), low-noise (resistors), etc. are used. / Whenreplacing
any of components, be sure to use only manufacture's specified
parts shown in the parts list.
* The parenthesized indications in the Remarks columns specify
the areas. / Parts without these indications can be used for all
areas.
* Remote Control Ass'y: Supply period for three years from terminal
of production.
* Capacity values are in microfarads (uF) unless specified
To Next Page
Loading...
