Technics SL-BD21 - Page 6

How to remove the tonearm and PU fixing plate |
Procedure
3040809
Holder
1.
Unsolder
the
5
PU
lead
wires
from
the
phono
"
Spring
terminal.
2.
Remove
the
spring
holder.
3. Remove the setscrew @.
4.
To
remove
the
tonearm,
remove
the
2
setscrews
(@.®).
5.
To
remove
the
PU
fixing
plate,
remove
the
2
setscrews
(@,
@).
*
PU
lead
wiring
method
L channel (+) terminal
L channel (—) terminal
R channel (+) terminal
R channel (—) terminal
Ground terminal
PU fixing plate
Note:
If the cueing time of the tonearm becomes too short, or
if the cueing cam is replaced, apply silicon oil (Part No.
$ZZ0L12) according to the following procedure
1. Remove the cueing cam.
2. Apply silicon oil to the cueing cam and oil tank.
Pin,
How to remove the cueing cam
Procedure
30498010
1. Push the pin with a driver.
2. Remove the pin and spring holder.
3. Remove the cueing cam.
Cueing cam ——
Apply silicon oil
Notes:
1.
When
attaching
the
turntable
drive
motor
to
the cushion
rubber,
match
the arrow
marks.
2. Connections of the turntable drive motor:
FC3 © terminal. ..(+) terminal of the motor
FC3 @ terminal. ..(—) terminal of the motor
How to remove the turntable drive motor
Procedure
3e4en
1. Remove the motor assembly 3. Pull out the motor pepe 2
in the direction of the arrow. from cushion The arrow mark indicates the (—) terminal
2. Unsolder the 2 lead wires rubber.
from the motor.
Arrow mark on
, Motor cushion
rubber
Arrow mark on
turntable drive
motor /