Technics SL-BD22D Service Manual

Ref. No
10
How to remove the cueing cam
Note:
If
the
cueing
time
of
the
tonearm
becomes
too
short,
or
Procedure
39408010
1. Push the pin with a driver.
2. Remove the pin and spring.
3. Remove the cueing cam.
if
the
cueing
cam
is
replaced,
apply
silicon
oil
(Part
No.
$ZZOL11)
according
to
the
following
procedure.
1. Remove the cueing cam.
2.
Apply
silicon
oil
to
the
cueing
cam
and
oil
tank.
Pin
Cueing
cam
—_—c=
SS
Apply silicon oil
element
How to remove the magnetic resistor
Note:
If the magnetic resistor element has been
Procedure
304011
Remove
the
motor
assembly
in
the
direction
of
the
arrow.
Mi CONNECTIONS
replaced, observe the following mounting
precaution.
The magnetic resistor element is supplied with
the center lead bent. Be sure the seat the bent
lead flush to the P.C.B.
This will ensure the proper clearance
(0.8+0.2
mm)
between
the
magnet
and
the
magnetic
resistor
element
as
shown
1, Unsolder the 3 lead
wires from the
magnetic resistor
P.C.B.
2. Release the claw and
pull out the P.C.B.
3. Unsolder the 3
terminals of the
magnetic
resistor
below.
+0
element.
Magnetic
6194
mm
Pull
out
resistor
\
0.840.2
mm
ry
element
Magnet
|
1.5mm
Holder
wel
t
Holder
PCB.
AC
power
supply
cord
(included)
To
household
AC
outlet
or AC outlet on amplifier
a)
—Os
2
t
GND
PHONO
4
@
o-000
ord
l
'
@!000
(PNL)IGND)
=
ar
tt
Ground
wire
(included)
foba
Amplifier
If the ground w
a “hum” ni
S NOt Connected.
@ may be heard
Stereo
connection
cable
(included)

Technics SL-BD22D Specifications

General

Brand	Technics
Model	SL-BD22D
Category	Turntable
Language	English