Technics SL-D303 E - Cartridge Installation

SL-D303
m REPLACEMENT OF HALL ELEMENT
When replacing the Hall element of the stator frame, be
sure to place it with the marking side up as shown Fig. 7.
* The leg position is not specified provided that the mark-
ing side is up.
m CARTRIDGE INSTALLATION
When installing a cartridge, follow the instructions that
came with the cartridge.
1. Connect the lead wires to the cartridge terminals.
The terminals of most cartridges are color coded.
Connect each lead wire to the terminal of the same color.
White (L+)........... Left channel +
Blue(L—) ........... Left channel —
Red (R+)............ Right channel +
Green (R-) .......... Right channel —
2. Mount the cartridge in the headshell using the screws
provided with the cartridge. (Fig. 8 }
@ ABOUT CARTRIDGE WEIGHT
(See chart below)
Cartridges weighing between 3.5 and 7.5 g can be used on
this tonearm (with the headshell and accessory shell weight
supplied).
Supplied headshel! in combination with other parts.
YY
_ GE
Headshell only (7.59)
Shell weight
Stator frame
Fig. 7
Screw
Washer f %
(Shell weight)
QE
Cartridge
Stylus protector
Fig. 8
Allowable cartridge weight.
(included the cartridge mounting screws)
49 5 6 7 8 9 10 11
a al i a Ne ee Be eS