Technics SL-D303 E - Page 9

MN
How to remove the drive circuit P.C.B.
. Remove the bottom board. (Refer to ‘“‘How to remove
the bottom board and automatic mechanism plate’’.)
. Open the “lead holder” of the lead connector and pull
out the lead wire. (Refer to ‘How to remove the stator
frame”’.)
. Remove the drive circuit P.C.B. setscrews @) ~ @ and
connectors @ and @). Then, the drive circuit P.C.B.
can be removed. (See Fig. 4)
How to remove the tonearm and lift base plate
. Remove the bottom board and automatic mechanism
plate. (Refer to “‘How to remove the bottom board and
automatic mechanism plate’’.)
. Remove the PU fixing plate setscrew @ and canceller
spring. (See Fig. 5)
. Unsolder the 5 lead wires from the tonearm. (See Fig. 5)
. Remove the tonearm setscrews @) and @ . Then the
tonearm can be removed. (See Fig. 5)
. To disassemble the lift substrate, diseangage the arm
lift fixing screw @ before turning over the body, the
remove the arm lift. (See Fig. 6)
Note: Remove the spring under the arm lift at the same
time.
. Remove the anti-skating control knob. (See Fig. 6)
. Turn over the unit and remove the PU fixing plate.
. Remove the lift base plate setscrews @ and @ . Then,
the lift base plate can be removed. (See Fig. 5)
| Lead wire
Lead connector
Drive circuit P.C.B.
Fig. 4
PU fixing plate —
Lead wire
Canceller spring ;
* Cueing lever
‘ Fig. 5
Tonearm
Anti-skating
control knob
Arm base
Arm tift
Fig. 6
Si a i El a et es De,