Technics SL-D303 E - Page 8

SL-D303
@ DISASSEMBLY INSTRUCTIONS ®—f to
mechanism plate
. Fix the tonearm on the rest.
. Remove the turntable.
3. Close the dust cover, and turn over the unit, taking care
not to scratch it.
4. Remove the bottom board setscrews @ ~ @. Then, the
bottom board can be removed. (See Fig. 1)
5. Remove the shield plate setscrews @ and@.
(See Fig. 2)
6. Remove the regulator transistor P.C.B. setscrew @ .
(See Fig. 2)
7. Remove the automatic mechanism plate setscrews @ ~
@ . Then, the automatic mechanism plate can be
removed. (See Fig. 2)
e How to remove the bottom board and automatic 0-7 |
NO —
Bottom board
Fig. 1
Shield plate
r—O
|
\
Automatic mechanism plate
lator
transistor
P.C.B.
‘
Regulator
Fig.
2
e
How
to
remove
the
stator
frame
Lead
wire
1.
Remove
the
bottom
board
and
automatic
mechanism
plate.
(Refer
to
“How
to
remove
the
bottom
board
and
automatic
mechanism
plate”.)
2.
Open
the
“lead
holder”
of
the
tead
connector
and
pull
out
the
Jead
wire
of
the
arrow
@)
in
Fig.
3.
3. Remove the stator frame setscrews @@~ @. Then the
stator frame can be removed. (See Fig. 3)
Drive circuit P.C.B.
Fig. 3
Stator frame